Questions & Answers for: time 91 mustang

Question about 1991 Mustang

1 Answer

91 four cylinder ford mustang the car wont pick up speed vary fast and its doggy also it always wants to quit running whens the last time you had a tune up, plugs and wires could solve this problem.

Ad

Question about 1991 Mustang

1 Answer

...91 ford mustang 4L and it won't start. when i turn the key the motor turns over the gas pump engages and there is no spark. can anyone help?? i had the same problem just a little bit ago with my 91 ...

Ad

91 ford mustang convertible driver side rear window is off track or something as it wobbles around and does not roll up and down smoothly you going to have to take it apart to get to it, is not that ...

...MUSTANG WORK IN A 91 CLUSTER PANEL BECAUSE THE 91 SPEEDO SPURATICALLY GOES UP AND DOWN i do not know but give these websites a try www.alldatadiy.com and www.autozone.com you can also stop by your ...

...91 mustang GT I need to take off the rear quarter panel windows of my 91 Mustang GT to repaint the molding that has faded, but I can't seem to find out how to get them off without hurting the window ...

...91 LX 5.0 mustang without removing the tank? no the tank must be dropped, it is a very easy job even on the ground, about 2 hours. No. Some guys cut a hole in the floor of the car after they take the ...

91 gt mustang with a 84 351 windsor that runs way to hot i put 4000 rpm flex fan with shrout brand new 4 core griffin radiator brand new water pump took thermost out put one in and it still over heats

Question about 1991 Mustang

1 Answer

...91 ford tbird 5.0 engine but oil pan has two humps in the oil pan and im train. To put in a 65 mustang You will need to change the oil pump pickup tube and screen / about ten bucks for the Melling ...

Question about 1991 Mustang

1 Answer

91 5.0 LX, ran fine yesterday but hesitated when pulling into the garage. Next morning it would crank over rapidly but won't fire. dosen't seem to be getting spark. Any ideas? Thank You. I ...

...91 ford mustang pull the spout connector (a grey jumper located in the engine wiring harness either near the code reader port or the distributor) and put a timing light on the #1 spark plug wire. ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...