this will be hard, but if it displays stuff, go to the menu and under user setting try changing the tilt
...slide switch and no button? How else can I get the tape out? Defective mechanism, a stucked mechanism is present. camcorder are smart it can detects error and shuts down itself for safety. earlier ...
...card? There's a slide switch on one edge of the SD card. Slide it away from the contacts. If that doesn't work, there's a problem with the mechanism inside the camera that detects the switch
...Slide it toward the contacts to enable write, away from the contacts to protect. If this doesn't do it, then there may be something wrong with the switch mechanism in the camera. Also, make sure the ...
Question about Lumix DMC-LC50 Digital Camera
...slide it fully away from the contacts, then toward them. If this doesn't fix it, try another card. If that doesn't fix it, then there may be a problem with the sensing mechanism in the camera which ...
tilt the lid slightly towards the front, and slide out to avoid the cd tray. BE CAREFUL not to damage the eject/power button ribbon cable, as these are very fragile. Gently pull the tray away from the
system eror Hi, This error usually comes due to faulty sliding mechanism.Put a bit of force on the focusing lens to push it back into camera casing. That's the reason the sliding mechanism won't work.
Question about Lumix DMC-LC33 Digital Camera
...mechanism is not closing completely unless you slam the door because the plastic parts don't slide easily after a couple of years. We found that putting a small amount of vegetable oil on the 2 ...
Question about Silver Tilt/Tilting Wall Mount Bracket for TH-50PX50U / TH50PX50U Plasma HDTV TV/Television
WHERE CAN I GET A TILT BRACKET FOR MY PANASONIC PLASMA TV MODEL TH-50PX50U? Well, the best and cheapest I have found was Walmart. However, most electronic stores like Radio Shack or Best Buy also ...
Question about Silver Tilt/Tilting Wall Mount Bracket for TH-50PX50U / TH50PX50U Plasma HDTV TV/Television
...tilt the vent grille louver above the door of the microwave down towards yourself. (The vent grille goes across the entire width of the microwave). Next remove three screws, one on each side and one ...
Usually answered in minutes!
100 Questions
69 Questions
39 Questions
37 Questions
25 Questions