...tighten your chain, and lift your swingarm up until its horizontal with the ground, then the chain should have almost no play. Not completely tight, but almost no play. Tighten the axel, and the bolt ...
chain and slung a rod .002-.004" Intake side .004-.006" Exhaust side plug out, take fat screw in select lever out, take pull start off, turn motor counter clockwise until you hit T I when that I lines
250. When it gets into top gear and reving hard it feels like geras are jumping or chain is jumping on sprockets. everything looks fine though. dude when u feel like dat just try to shift to ur 2nd or
...tighten the old chain with the chain tightener on the axle but im not sure how to move it back to where it was? HELLO; Heres all you should have to do this,set your quad up on a atv jack or on a milk ...
...250 will not idle rattling noise in 1st gear The bike seems to run strong when throttled up, but when its in 1st gear and im slowly strolling along theres a rattling noise somewhere down below me. It ...
timing chain how do you take the mag. and fly wheel off to chang timing chain for a 99 yamaha warrior 350 atv you need a fly wheel puller.
...tighten the chain on 2002 yz250? Loosen off the axle nut (B) until it is only lightly tightened. Wind out the chain adjuster bolts (C) evenly on both sides until you reach the desired tension. You ...
sounds like chain jumping sprocket on right side. 1978 Yamaha Moto 4 sounds like chain jumping sprocket on right side. does not drive. engine runs fine. Adjustment or real damage? only 900 origional ...
I need to tighten the rear shocks on my Yamaha YZ 250. How do I go about it? go get the wrench for it
how do i set the timing chane on my 250 4 stroke dirt bike set the chain? you mean the timing? did you take the cams off. let me know what ya wanna do
Usually answered in minutes!
453 Questions
76 Questions
10 Questions
1 Questions