Questions & Answers for: Dodge Durango tighten chain 250 kymco

Question about Dodge Durango

1 Answer

Tighten water pump mounting bolts to 40 N·m (30 ft. lbs.) torque. Position bypass hose clamp to bypass hose. Spin water pump to be sure that pump impeller does not rub against timing chain case/cover.

Ad

...250 in. lbs.) . Retract tensioner if required. CAUTION: The camshaft pin and the slot in the cam sprocket must be clocked at 12:00. The crankshaft keyway must be clocked at 2:00. The crankshaft ...

Ad

my 4.7 2002 dodge 1500 will not start i milled the heads and put on a new timing chain then when done it willnot start i think it fired a few times. MAYBE the cam sensor was defective the place i got ...

Question about 2000 Durango

2 Answers

...chain guide. Tighten the bolts to 28 N·m (250 in. lbs.). CAUTION: Overtightening the tensioner arm torx® bolt can cause severe damage to the cylinder head. Tighten torx® bolt to ...

Question about 2000 Durango

1 Answer

...chain tensioner and install the two (2) remaining bolts. 7. Tighten the pump and tensioner retaining bolts to 21 ft lbs in the sequence shown in attached photo. 8. Install the secondary timing chain ...

chain This is a specialty tool and you can probably borrow or rent one from Advance Auto parts or Auto Zone.They are also not to expensive to buy but since you will probably never use it again I would

...Tighten the bolts to 30 ft. lbs. (40 Nm) on pushrod engines, 40 ft. lbs. (54 Nm) on the 4.7L engine. Spin pump to ensure the impeller is not rubbing against the timing chain case. When installing the ...

I have a 2001 Dodge Durango my sprockets dots are where they are supposed to be but the white dots on my chain or not do the white dots on the chain matter I Assume you have a 4.7 liter V8, have you ...

where is the timing chain located on 2001 durango supersport its on the front of the engine behind the water pump Push rod V-8 5.2L and 5.9L . It's located behind the water pump in the timing cover ...

when a timing chain on a 2003 Doge Durango,Does it bend valves? if the timing chain brakes the valves could be bent. you could also have damage on your piston or the connecting rods. when the chain ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

1999 Dodge Durango
1999 Dodge Durango

2,049 Questions

2000 Dodge Durango
2000 Dodge Durango

1,616 Questions

2001 Dodge Durango
2001 Dodge Durango

1,378 Questions

2002 Dodge Durango
2002 Dodge Durango

886 Questions

2004 Dodge Durango
2004 Dodge Durango

1,005 Questions

Manuals & User Guides

Loading...