Questions & Answers for: tight oil filter cause leak

...oil filter conected to the filter housing. It looks pretty tight for any wrenches and was wondering how hard it might be to fix. Any help would be appreciated. Thanks Arthor ya honestly just fixed ...

Ad

Question about 2006 Passat

3 Answers

...oil on the rubber seal and istall the fiter to hand tight and a quarter of a turn. run the vehiculefor a minute shut off and check the oil level.adjust if required. check for leaks,if dry job is done ...

Ad

Question about 2006 Passat

1 Answer

...vw cabrio, it has a leak located behind the radiator. my coolant is completely empty after i drive it more than a couple miles. Even when i fill it to max. HELP You have a leak in the radiator and ...

Question about 1988 Cabriolet

1 Answer

...filter and oil has been changed. he has used a thin oil. sensors have been changed. Any good ideas. Where are all the sensors located? MY 1996 VW CABRIO HAS A HIGH OIL PRESSURE THE SWITCH IS BLOING ...

...and alarm comes on after driving the car a couple of miles . Oil is new and just changed. Make sure there was enough oil put in and that it is not leaking through the oil drain plug or the oil

...oil filter mount my 97 cabrio 2.0L is leahing oil from the top of the oil filter mount.It is leaking where the two parts of the housing meet. can this be repaired or replaced. Yes this a simple fix ...

Question about 1997 Cabrio

2 Answers

oil filter leaking i did got new oil filter but still leaking Hi Are you sure its the oil filter? it could be the oil filter gasket, some models/ not all vw have a second gasket seperate from the oil ...

...oil filter a quarter turn after its tight. If you over tighten it this will blow the new seal and cause it to leak also. Try out this site as their is as seal above it that is known to leak. ...

...from the part where the oil filter goes check that the oil filter is tight ( hand tight plus 1/4 turn) over tight causes problems with leakage . Check that there is only one gasket under the

...oil on the O ring, put the filter on hand tight, and then another 1/4 turn with the wrench, not too tight. if its not the seal they are talking about it then may be the oil cooler itself. On these ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...