Question about Fatmax Xtreme Retractable Utility Knife
thumb lever. good luck What a wonderful way to slice your fingers and jab a hole in your hand!!!!! This tool must of been added by an engeneer dropout!!!! A real utility knife would of had
...blade in a stanley fatmax? You do not have to remove any screws. Extend the blade outward using the thumb slide on top of the knife. There is a small black pushbutton on the opposite side from the ...
Question about Fatmax Xtreme Retractable Utility Knife
...asked for, if you need instructions for the pictured 10-816 please re-post the question. Push the thumb slide forward as far as it goes exposing the blade. Press the blade change button on the side ...
Question about 12 - 905 Contractor Grade No.5 Smooth Bottom Jack Plane
I just received a new Handyman No4 but I dont know to where to set the adjusting nut! Does the "horse shoe" fit inside the plastic in the nut or in front of it? The instructions provided are
Question about 12 - 905 Contractor Grade No.5 Smooth Bottom Jack Plane
I have a Stanley Bostitch N80SB with the sequential trip kit. I have installed a new trigger valve assembly, and the unit now holds air pressure, but the trigger will not activate the plunger. I can ...
how do you put staples in There is a thumb release lever that keeps the slide bar locked down. Take your thumb and push up ******* this plastic release and it should open so that you can add staples.
Question about Tools TRE550 Electric Staple/Brad Nail Gun
how do i release the staple holder on a tre550 Push up ******* the plastic thumb lock. It is the plastic mechanism at the end of the slide bar.
Question about Tools TRE550 Electric Staple/Brad Nail Gun
...staples in this stapler 1. Hold the black handle -- top part -- of the stapler with your right hand thumb and forefinger. 2. Hold the metal casing right beneath the black handle, with your left ...
Question about Tools TRE550 Electric Staple/Brad Nail Gun
adjusting stanley block plane G12-060 Adjust the mouth opening by loosening the front knob, then turning the little lever under it to move the sliding "tongue". Adjust the iron extension by turning ...
Question about Tools TRE550 Electric Staple/Brad Nail Gun
how do you load staples into Stanley TR110 Lockdown lever, pull out loading mechanism, place staples into the tool with staple points facing up. Close loading mechanism. Unlock lever. Ready to use.
Usually answered in minutes!
20 Questions
11 Questions
26 Questions