...thumb screw back into hole and tighten until firm. IMPORTANT: place the moving arm the protrudes from the walking foot ABOVE THE NEEDLE BAR, so that as the needle bar goes up and down ...
feed dogs Elna How do I lower the feed dogs on my Elna Quilter's Dream slide the accessory case off; locate the feed dog lever on the back of the free arm. Slide the lever either to the right (down) ...
Speed lever cover plate came off and speed lever also. cannot see how to reattach. pjk6 Managed to centralise electronic speed control. This is OK for us as machine only used very occasionally. Left ...
...thumb screw. Now fit the walking foot on instead by putting the lever arm around the needle bar and the curved bracket around the pressure bar and then putting the thumb screw back into place and ...
I have an Elna 2730. the feed dog is not transporting the fabric anymore and the needle just keeps stitching in the same place. is it broken or just needs adjusting? if you have a manual, look to see ...
the feed dog of model 3230 is not working I have to full the fabric in order for it to sew and the stitches are very tight check your top thread tension for the tight stitches check your manual for ...
lever and it is almost impossible ...can do it but end up with raw thumb! this is probably due to lack of use and just stiffening up of this lever, best thing is to take off the top cover and get some
Where is the foot lever on the Elna Pro 4 DE, Am unable to locate information on your machine. However, the presser foot lever is usually located behind and above the presser foot. Instruction Manual ...
Question about Quilter's Dream 6003Q
Elna lock pro dc 5 upper looper release lever won't move to the left I have an Elna Pro 5 DC and I'm looking for help on the upper looper release lever. There's only 2 ref to it in the manual. 1st ...
Question about Quilter's Dream 6003Q
How to replace presser foot LEVER on Elna 9000 Computer model? The 9000 Computer model is no longer serviced by machine shops in my area, because there are so many plastic parts in the inner workings,
Usually answered in minutes!
175 Questions
46 Questions
36 Questions
24 Questions
21 Questions