Questions & Answers for: Canon thumb lever

...thumb" screw on the front of the drum unit, its almost like the knob on a gumball machine as you are gripping a slotted "knob".turn it counterclockwise and remove it (you will use it to install the ...

...rounded protrousions inside towards the rear of the black box, grasp these protrousions with your thumbs and forfingers and gently pull toward you, ther may be some resestance but pull smoothly do ...

...lever on the right, lift it up. Between your thumb and index finger, grasp the pring head and pull it up out of there. Dont touch the contacts at the back. Run it under warm water for about 5 minutes ...

...Lever firmly and lower it gently. Once you have installed the Print Head, do not remove it unnecessarily. Install the Ink Tanks Pull the orange tape (1) in the direction of the arrow to peel off the ...

... plastic levers that you can see in front of you. The drum is held on with one screw, it's either a thumb screw or a Phillips #2 screw, just remove the screw and pull the unit out, it's about a foot ...

...must slide out in order to dump out the waste toner. The drum cartridge is held on with either a thumb screw or a #2 Phillips screw which you need to remove first. Next you will want to lower the ...

...thumb and index fingure) and under a tap of slow warm water for about 5 minutes or earlier if the water dropping off the bottom is clear, and dont aim at those silvery things. Give it a tip and a ...

...lever attached to the cover of cartridge . Just hold the front ant and top of the cartridge with middle fingers and thumb fingers either side of the cartridge by both the hands and just press the ...

...out I use my fingers as a lever on the bottom of the hopper then push the shutters closed with my thumbs. My customers were not very comfortable with this

...lever under your right thumb usually have a rewind crank at the left hand end of the camera . Generally it is on the top folded into the round thing but sometimes it is on the bottom in a matching ...