Questions & Answers for: Pontiac Bonneville throttle plate

...throttle plate ,put a used sensor on the canister under the ecm ,put a a new gas tank in the car because of a pinhole in the tank and when i did that i put in a new vapor sensor to be safe and also ...

...flashes. Try unplugging and re connecting the atmosphere temperature sender, typically before the throttle plates in the air cleaner.. if the condition continues, replace the

...throttle plate inside and out and also the back of the throttle plae, many times the plate sticks from back firing that you can't detect by ear or feel. Also could have a plugged cay. The only thing ...

plate and bore with a clean toothbrush and throttlebody cleaner with the car OFF. You don't want anything going any further inside and depositing all over and/or starting a fire...disregard any STUPID

throttle plate it may have carbon build up on it. also make sure air filter is clean and check or replace the intake air tempurature sensor.(iat) sensor. the sensor is under 20.00, the sensor is after

...throttle plate til the tarish stuff is gone.You should be able to feel the plate not stick by moving it by hand to the open and close position.You can also spray it down with the cleaner before you ...

...throttle plate on my 2004 pontiac bonneville. I am trying to do a fuel system tune-up and I am having trouble locating where this is to clean it out. the throttle plate is located inside the intake ...

time goes on. clean around throttle plate good to remove the gum and varnish from around plate. you can buy throttle body cleaner at most auto-parts stores. and make sure airfilter is clean. good-day

...Just replaced all my brake lines. Now when I start it, it will rev up to 4000rpms. Could be the throttle plate is stuck open, you have a large vac leak, or the idle air control valve is stuck

...between 2600 and 3000 rpm after start up Is the check engine light on ? Have you checked the throttle plate to see if it is not closing, the idle air control valve, and if you have any vac leaks