Questions & Answers for: Ford Escape throttle plate

...connected to. Try holding foot on gas just a little if engine doesn't stall,prob is likey your Idle control motor IAB as ford calls it,also look for build up on throttle body and plate..clean as ...

...trick if the pintle valve inside is grunged up. if it is an abrupt stall it could be a torque converter stuck in lock up. If is stalling due to low throttle you might try to clean the throttle

...throttle plate with some carb spray. With the engine off and preferable with the engine cold remove the air snorkel from the throttle body. Open the throttle body and see if the throttle plate has a ...

...throttle plate is too dirty and needs to be cleaned.if you remove the air snorkel and look inside to see the throttle plate it will probably look black or brown around the edges this is build up ...

...throttle plate.Use an air intake cleaner to clean around the it.Do not use alot of cleaner and start up the truck in between rounds of cleaning.Be sure to reconnect any connectors that you you may ...

code p2111 detected throttle plate is at a greater angle than commanded look for carbon build up on the throttle plate

...hit it when I was sitting in stop and go traffice. Either your throttle cable or throttle plate is sticking. This most likely do to moisture on the cable or in the mechanism freezing do to the

...it -help Any DTC'S - diagnostic trouble code's ? How many mile's on the vehicle ? Timing chain problems , VVT - variable valve timing ,do you know what that is . Clean throttle body ,throttle plate

throttle plate and where it seats. Pull the mass air flow sensor and spray it down thoroughly. Front and back. Don't use the brush on it. You can break it. Reassemble it and remove the top part of the

...throttle plate and surrounding bore with an old tooth brush and some carb cleaner. Be sure to spray some into the small holes next to the throttle plate. That should help stabilize the idle. If it ...