...throttle plate. The gas pedal you press is cable connected to a sensor called the APS (Accelerator Position Sensor - which could also be the cause of your 'downshift by itself' issue. Both these ...
where is the throttle position switch It is on the throttle directly across from where the cables are, that move the throttle plate.
...clean the throttle body especially were the throttle plate sits at idle,use a tooth brush and carb cleaner.dirty throttle bodys cause that code and many others.also cause iratic idle and/or
...throttle plate edge. It is likely that oil deposits are lining the throttle opening and this causing the plate to stick so that when you press of the accelerator the throttle plate stays closed and ...
throttle plate and the throttle position sensor (potentiometer), which are integrated in one housing. The actuator consists of a DC motor with a two-stage gear. The opening angle of the throttle valve
...of carburator, and one at accelerater pedal check this one first. the throttle body does not need to be changed to fix the tps. but usually it is located on the throttle body. at the throttle
throttle plate. Reach and pull on throttle cable to open throttle plate fully. When open coat throttle plate good with carburetor cleaner, take toothbrush and scrub carbon deposits from throttle plate
...spots (in the potentiometer). You may also have carbon/soot buildup on the throttle body thottle plate causing it to stick. Standard throttle/choke plate cleaner will take care of the throttle
...throttle plate. Usually you can clean enough dirt to restore it. Best way to do it is to remove the air cleaner hose from the throttle body, open the throttle by hand (engine off) cleaning the plate ...
Usually answered in minutes!
1,503 Questions
1,180 Questions
1,131 Questions
1,254 Questions
1,082 Questions