Questions & Answers for: Ford throttle plate

...throttle plate My son took his 91 crown Vic to a mechanic to have it checked out because it is running real ruff. He was told it needed a tune up and the throttle plate needs to be cleaned. I use to ...

throttle plate and throttle plate bore hole to smooth it out and idle correctly. if it is running low RPM then you need to check air filter PCV valve and lube throttle plates and cables. The 1997-2002

throttle plate causing a small amount of air to leak past the plate when it is closed (at idle). Spray cleaners are available at auto parts stores, after removing the air plenum tube from the throttle

...throttle plate to control idle airflow as part of the sludge tolerant design. Throttle bodies with sludge tolerant design are clearly identified with a Yellow/Black decal. This decal warns that the ...

...throttle plate with some carb spray. With the engine off and preferable with the engine cold remove the air snorkel from the throttle body. Open the throttle body and see if the throttle plate has a ...

...throttle plate. A throttle position sensor (TPS) on the throttle plate shaft feeds back to the ECM the position of the throttle plate. If there is an interruption of signal either to the TAC or from ...

...can also occur from a really bad COP Ignition Coil spiking the PCM (computer) and coming back on both sides of the TPS Sensor. You then loose throttle plate position and thus shut down or go only 6 ...

...throttle plate and bore.if its dirty clean it this may be all you need to do.if the shaft binds then clean the shaft area to see if it fixes the problem,if not then the throttle shaft may have to be ...

...throttle plate for dirt as this will cause a stall.the throttle plate is located in the intake were the air snorkel fastens to the intake manifold.if you look inside the intake you will see a gold ...

...throttle plate and surrounding area with Carb cleaner, it may just not be getting enough air at idle do to carbine (Muck) deposits around the throttle plate. I would take off air cleaner hose, soak ...