Questions & Answers for: Chrysler throttle plate

THROTTLE BODY/PLATE..YOU CAN REMOVE THROTTLE BODY..FIRST REMOVE AIR CLEANER,UNPLUG TPS,IDLE MOTOR AND INTAKE TEMP SENSOR..USE BRAKE CLEANER OR THROTTLE BODY CLEANER AVAILABLE AUTO PARTS STORES..DO NOT

...throttle plate located as I hear it needs to be cleaned else it will cause problems. The engine currently will not idle unless the throttle is advanced some after the battery was replaced. I ...

...when the electronic throttle control warning light comes on the dashboard if it was me i would get the throttle bore cleaned or clean it your self must be build up at the throttl plate have the car ...

...throttle plate can open to maintain a good idle RPM, if this amount is exceeded, the PCM will set this DTC. I have seen this on many ETC vehicles such as your Mustang. The proper procedure is to ...

my idle is too high Could be a long list of things including a dirty idle speed control valve, dirty throttle body, sticking throttle plate or throttle cable.

...the key on & have someone push on thegas pedal while you watch the throttle plate moveSome of them snap closed when you let off the gas& then return to where they are set for proper ...

...the throttle body is at the end of the hose going to the air cleaner. It has the throttle plate with the cable attached. The upper plenium goes over the valve cover and attaches to the lower

...throttle plate need to know how to clean a throttle plate Remove air cleaner. With engine off and cool. Spray carburetor/fuel injector cleaner down intake throat, onto throttle plate while moving ...

...throttle plate onto the shaft. The back ends are usually flattened to prevent them from backing out but if someone was in there and didn't reinstall them correctly for whatever reason, the throttle ...

...throttle plate and measure the position of the throttle - essentially, how far down the gas pedal is pressed The throttle position sensor on a 2007 Chrysler 300 3.5 liter is located on the throttle ...