Questions & Answers for: Briggs & Stratton throttle plate

...enough to move the cable. Start the mower and adjust the idle by the screw that touches the same plate that your cable hooks to. Then push the throttle control to idle and retighten the cable

how does choke work on 20 horse briggs the throttle only has turtlespeed and rabbit no place marked choke Many have auto chokes, which are set to close and open essentially with spring pressure. You ...

...throttle plate where the throttle lever connects to...also, there are several holes in the plate where the spring attaches...these hole will set the sensitivity of the govenor...you may need to make ...

...running power by finding the idle increase on the spring choke. thers a lever on the throttle plate that has a spring on it bend it a little to put more tension on the spring that should speed it ...

engine idoling way to high An engine will idle too high because of : improper govenor setting, improper carb setting, intake leak, or missing carb throttle plate.

Throttle plate sticks When I reassemble carb the throttle plate is pushed up and then sticks. Float is in tank properly, gasket sits well in its groves/slots. Seems top of plastic float is pushing the

...throttle plate where it is ungrounded - meaning, not electrically shorted to the main body of the metal of the engine. When the engine control is moved to off, stop, etc - that plate makes a ...

...throttle is applied, bend the plate till it does. Then take a pair of pruners ( or a chainsaw ) and low prune your bushes around the lawn , it looks pretty and will stop it happening again. Happy ...

...throttle plate to the governor arm. On the arm there will be several holes. If you didn't pay attention when removing old spring then look at arm and you should be able to tell where spring was by ...

...other will connect to the plate at the end of the throttle cable under the insulated bit when you push the throttle to stop , that plate will short out the wire with the stripped end and top the ...