Questions & Answers for: Dodge Ram 1500 throttle body

...throttle body off, clean Throttle Body with Carburator cleaner. I had same problem and its the ethynol in fuel that creates a build up in the throttle body which creates this problem. I did what a ...

...throttle body terminal A and PCM terminal 1B ? Short to power supply in wiring harness between throttle body terminal A and PCM terminal 1B ? Short to GND in wiring harness between throttle body ...

...throttle body needs to be replaced. The engine has 108,000 miles. Is this the real problem and how much of task is to to replace the throttle body gasket? I do know these are good for sucking in the ...

...throttle body. With the advent of computers this setup is slowly dying off in favour of another one called drive-by-wire. Essentially your pedal is no longer connected to the throttle body. A sensor ...

throttle body faulty throttle position switch sometimes the idle speed needs to be adapted using diagnostic equipment Try cleaning the throttle body, it collect junk that passes through the air filter

...throttle body along with the Throttle Position Sensor TPS. The throttle body houses the throttle plate which either has a cable or electric motor that responds to the gas pedal. It is located at the ...

...throttle body. Over time on high mileage vehicles, the throttle body butterfly valve will gunk up with sludge, and dirt. This will prevent air from entering the intake manifold while the engine is ...

...throttle body. If that is free, examine the other linkage components for binding. If the throttle is still stuck is likely that the throttle valve is sticking in the bore. Remove the intake hose from ...

...throttle body and goes down to the trans) - open the throttle body manually all the way (Wide Open Throtle) the TP cable should have all the slack taken up. From your symptoms I would expect to see ...

...throttle body was replaced what did i miss i replaced the throttle body and throttle position sensor i still have the red lighting bolt code and now i have a approximate 30 second delay between ...