Questions & Answers for: Chevrolet Blazer throttle body

...run while the gas in there but not afterwards bad throttle body or injector, 97 blazer runs smooth..but once it sits 30 mins or more it will not start without sprayin starter fluid in throttle ...

Ad

Question about 2000 Blazer

1 Answer

...throttle body remove all electrical parts also all plastics and rubber parts.clean throttle body with gum out throttle body cleaner.dry off throttle body.replace gasket.scan it to check to see if egr ...

Ad

Question about 1990 S-10 Blazer

1 Answer

...throttle body and find the part that looks like what you just brought. Its easy to install it has two small screws attached on the side of what used to be a carbuertor it is now called the throttle ...

...throttle body. so what could be the problem Fuel does not go into the throttle body on that engine. nThe throttle body is for air intake only. Fuel goes to six individule injectors via the fuel rail. ...

throttle body, When cleaning your throttle body pay attention to your IAC (Idle Air Control) valve passage way with is located on the back side to your throttle body air intake barrel. Just follow the

...Throttle body with throttle body cleaner or Deep Creep made by Seafoam. When the carbon and varnish build up in your throttle body get's hot, it gums up the IAC (Idle air control) valve which help ...

Question about 1995 Blazer

2 Answers

...throttle body, build up can form up in the throttle body and make it harder for the sensors to get accurate readings. Air Idler Controller, throttle position sensor are normally connected to the ...

Question about 1989 S-10 Blazer

1 Answer

...SUGGESTIONS? with the 4.3 tbi system stock the throttle body is slightly too small for an instant response from throttle the best advice is to either use a throttle body spacer or deal with it ...

Question about 1993 S-10 Blazer

1 Answer

...throttle body, turn switch to accessory position fuel should flow freely. no flow check filter located on frame rail. or defective fuel pump. pressure should be(if checked with good guage)45-55 psi. ...

Question about 2005 Blazer

1 Answer

throttle body diagram how to clean throttle body Buy a new-gasket, unbolt throttle-body, spray carb cleaner inside of throttle body let soak respray take a long Handel like tooth brush an clean it ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...