Questions & Answers for: Lexus throttle body

...Throttle Body Plate attached pic is LS400 model 2000 throttle body Can any one tell me how to adjust the plate of the throttle body ? what are the two screws shown in the picture? ...

throttle body concerning the GS300 (1998 in my case) My symptons were: VSC, VSC OFF, and ENGINE Lights would come on, followed by my car going into Limp Mode, where only that last 25% (if that) of the

...lexusRS300,3litre; When I come to a Hi, my 2000 lexusRX300,3litre; When I come to a stop the idle drops and the full suv rumbles. clean throttle body how to clean throttle body for 2000 lexus ...

Throttle body has been cleaned out but problem does not go away. I also have a 2000 ES300 and I had the same problem where it would idle so low to the point of stalling and sometimes it would. Its not

...throttle body , which should consist of two connectors and two coolant hoses and the throttle plate cable. all very easily accessible. once you have the cable, connectors and coolant hoses ...

...always on the throttle body by the hose that connects to the throttle body push gas pedal look under hood while doing this and you will see the throttle cable moving on throttle body right around ...

...throttle body gasket, an air filter, an air compressor, a blow gun, a magnetic pick-up tool and a socket set with ratchet and extensions. You must remove the intake air resonator, the #3 timing belt ...

throttle body bolt torque In order to install the throttle body bracket and tighten the retainers to 15 ft. lbs. (20 Nm).Hope this helps; also keep in mind that your feedback is important and ...

...throttle body how do i bring it back to 1200 rpms make sure you reassembled the throttle body properly you could have damaged the throttle body do you have a manual adjustment at your throttle body ...

...throttle body opening closing of the throttle body is there a simple solution to this problem so it don't spit and sputter and cut off Spray it with carberator cleaner to get the gunk. You ...