Questions & Answers for: Dodge throttle body

...throttle body housing find your air filter and follow its assembly back to the throttle body this what your looking for the throttle is stuck by some build up in throttle body use some fuel injector ...

throttle body flap? It stcks closed and stalls until it warms up.Thanks, Jon clean the throttle body and flap. with the a tooth brush and throttle body cleaner from the parts store.this should fix the

...throttle body and check to see if the throttle body is sticky or stuck.  Make sure the throttle blade in the throttle body moves freely and returns to the close position without any problem. A ...

...throttle body is most likely dirty and making the throttle stick. if you follow the cable to where it goes to the motor that is the throttle body and if you clean that inside by taking off the air ...

...throttle body. Use a throttle body cleaner and do not flood the throttle body with the cleaner. You will have to open the throttle up and spray around the butterfly. It most likely carbon buildup and ...

throttle body and throttle plate for excessive build up. Remove the air cleaner assemble and use a flash light to look into the throttle body and manually open the throttle plate by moving the linkage

...side of the throttle body. If you look under the hood, where the throttle cable is attached to the drivers side of the throttle body, it should be on just the opposite side of the throttle

...throttle body and goes down to the trans) - open the throttle body manually all the way (Wide Open Throtle) the TP cable should have all the slack taken up. From your symptoms I would expect to see ...

...throttle body. Perform a throttle body cleaning and idle relearn after. Check for vacuum leaks. It needs some technical assistance, try out www.reliable-store.com they will get you simple info easily ...

...throttle body. Disconnect the electrical connector at TPS. Disconnect the electrical connector at IAC. Remove the throttle and speed control cables from throttle body. Remove 3 mounting bolts from ...