adjust throttle but there is not an adjustment on throttle body That is correct. throttle adjustments are controlled by the computer. Any other adjustments will need to be done with a graphing display
I know its a stupid qeustion but where exactly on the motorcycle is the air screw and throttle screw. I have a 2007 Suzuki rm125. The air mixture needle valve is on the Carb. Throttle screw as you ...
Question about 2002 FLHR - FLHRCI Road king
...adjust the throttle cable, you must insure that it operates correctly. Twist the throttle to the wide open position, with the engine OFF of course, and release it. It must automatically return to the ...
adjust the throttle & idle cables on a 2009 sportser Each cable has an adjuster near the throttle grip. They may be covered by a rubber boot. Slide the boot up so you have access to the adjusters.
Question about 2006 XL 1200 C Sportster Custom
...Adjust the throttle cable first. Adjust it until it has just a bit of freeplay in the cable. As you attempt to twist the throttle, you should feel a little freeplay before you feel the throttle start ...
...connect to the throttle body. When cables have been install and all parts reassembled you can carefully adjust the tension on the cables until the throttle responds the way you like it. Hope this ...
...adjust the throttle cable slack on a Piaggio ET2, you will need to locate the throttle cable adjuster. The adjuster is typically located near the carburetor or the throttle body. To adjust the slack, ...
Question about 2006 FXDI Dyna Super Glide
...adjust the throttle cables turn the cable adjusters and jamnuts as short as they will go so that both cables will have zero adjustment at the start of the adjustment procedure. THEN with the front ...
adjust idle Hi Rick: There is usually an Idle adjust or throttle stop adjust on the throttle linkage at the Carb. If fuel injection, check the throttle control linkage for an adjust screw.
Question about 2006 FXDI Dyna Super Glide
Briggs and Stratton would backfire and surge from about 1/2 throttle to full throttle. I cleaned carb, adjusted valves and governor. Now it idles at a excessively high speed and wont throttle down. I ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions