...of lower looper and upper looper. First raise the presser foot lever, and then thread the needle threads in order shown in color coded thread guide. I "might" be able to help you, what is your ...
bobbon thread is too losse /thread breaks no bobbon thread is too losse /thread breaks /no mater what stick i use have sewed in high school tryed all I know to fix Clean out the bobbin area. Thread ...
I have a hard time threading this machine and a hard time getting the bobbin thread to come up. Hello Place spool of thread on the spool pin, found inside the carrying handle on the top right side of ...
How to thread the machine Hello Place spool of thread on the spool pin, found inside the carrying handle on the top right side of the machine facing the back. Lead thread through the upper thread ...
...Be sure to ALWAYS RAISE the presser foot when threading the top thread. Also, since you are using 2 threads, thread one completely and then thread the other so the threads do not get twisted in the ...
Question about 2037 Mechanical Sewing Machine
L5 serger overlocker. Why don't the threads make a chain? rethread machine, make sure u thread all steps FIRST: Remove ALL the threads from your machine by clipping the threads between the spool and ...
Question about 2037 Mechanical Sewing Machine
... the looper would be threaded on top and cannot sew without breaking the thread. Make sure that the threads are bedded between the tension disks. Check this by stretching the thread fore and aft of ...
Question about 2037 Mechanical Sewing Machine
...thread keeps snapping. How do I stop this ? Third thread--is that the upper looper? Remove all the threads from the machine. Clip them below the thread tree, RAISE the presser foot, and then pull
Question about 2037 Mechanical Sewing Machine
...and the Nr 3 thread keep on breaking. What's wrong? Most often, it is misthreading. Remove all the threads from the machine. Then rethread each thread in the order specified and verify the thread ...
Question about 2037 Mechanical Sewing Machine
...Is that a Bernina? Which model? Usually, if you are experiencing improper stitching and/or broken threads, it's most often a mis-threading problem. Proper threading is EXTREMELY important to ...
Usually answered in minutes!
760 Questions
764 Questions
564 Questions
565 Questions
372 Questions