How do you load the bobbin properly? Hi there, Well you may please follow the steps below - 1. Remove the bobbin from the sewing machine. Note: whether you have a drop-in, front or side-loading bobbin
I own a "Lena" machine I own a "Lena" machine and after cleaning the entire bobbin area cannot get the bobbin to feed up and only have the upper thread. Hello Make sure your feeddogs are up.
Question about 5050 Mechanical Sewing Machine
The upper thread is too loose and the bobbin thread is taken up too much It is the upper thread which pulls the bobbin thread up. If the bobbin thread is taken up to much, one solution is to loosen ...
Question about 5050 Mechanical Sewing Machine
I have a faithful 730 Bernina and currently the bobbin thread keeps breaking. Please advise what may be causing this. Thanking you. My faithful 730 Bernina is currently breaking the bobbin thread. Can
thread a bobbin on a 5825c If you mean the Singer 5285C, the manual is available from Singer here: http://www.singerco.com/uploads/download/449_5_6_8_10_slide.pdf . The diagram for winding the bobbin ...
Question about 5050 Mechanical Sewing Machine
my bobbin thread breaks too much. How do I fix it. Be sure you are using the correct bobbin for your machine. Even though it appears to fit the bobbin case, if it is the wrong bobbin, it could cause ...
My bobbin winder will not engage 1. Turn the power on the machine. 2. Open the bobbin winder cover at the top on the right side of the sewing machine. 3. Swing up the bobbin thread spool pin. Move the
threading bobbin on model #385.19106900 Do you need to wind a bobbin or place it in the bobbin case for sewing? For bobbin winding, make sure that the top thread is on the spool pin with the ...
Question about 5050 Mechanical Sewing Machine
babylock enterptise embroidery machine. bobbin thread stitches get pulled up to top of fabric. How do I adjust tension to fix this problem? Bobbin thread showing on top side means the top thread ...
my bobbin wont pick up on me simplicity se3 Make sure the needle is not bent and fully inserted into the holder. Replace needle if in doubt. Be sure the bobbin is properly loaded onto case. Only use ...
Usually answered in minutes!
760 Questions
764 Questions
564 Questions
565 Questions
372 Questions