Questions & Answers for: thimble

Missing Thimble screw I have a Mitutoyo NO. 126-137 SN 6044681 Pitch micrometer. The end screw to hold on the ratchet thimble is missing. Where do I get a spare? You can most likely get one at a clock

thimble on 0"-1" micrometer is tight. micrometer will not read and is very tight. spray some silicone into the thread areaand open and close it a few times.

...connection in main power cable: 1.Open the dashboard 2. There will be black and red cables, if the thimble(Y shape metal used to hold the wire) is loose than tighten it with the help- of plier 3. If ...

I got the thimble zero to line up with the sleeve, but it is on the opposite side! How can I rotate it to the proper side? I have to hold it upside down or turn it around to read it. Would be nice if ...

... see if front of the radiator there are two or one horns ... check the wiring is it not loose or thimble removed .. connect the thimble back if it is loose ... if it is served or cracked . reconnet

i need a replacement thimble lock for a mitutoyo 6-12" outside micrometer(104-138 s/n#1080588). i image the 6 - 12" is a fairly expensive set. you could buy the 0-1" which has the same thimble lock. i

...wrench (supplied with unit), then tighten cap lightly with fingers to bring slight tension between thimble and spindle. 3. Bring anvil and spindle together by turning SPINDLE and set zero line on ...

...you need to check is the exhaust tube. Take it off of the back of the machine and off of the wall thimble and clean it out completely. While you have it off clean out the dryer where the hose ...

Scosche FMTD3 FM Transmitter - metal thimble at end of device not extending and seem to have losts its force to extend. What internal parts give tension to this metal thimble? Unscrew the end and ...

...0-1 inch rod all the way up into the base of the tool. Place the base on a flat surface. Turn the thimble ratchet clockwise until the measurement rod tip is stopped by the flat surface and the ...