Questions & Answers for: Sharp thermal copier

copier z 57 II black copy, lamp replaced but still not on? Apparently there isn't any power to the halogen lamp, which I replaced because I thought it was bad. Of course it does not light up. Is there

...code on a sharp copier inicates a problem with the heat lamp.Often a bad lamp, sometimes a thermal fuse.You should call a copier service technician.There are lethal voltages in this machine.Good

thermal fuse------bad lamp connector----shut down the copier and leave it to cool down------clean all above from dirt and toner deposit and check-----lamp----fuse---thermistor by avometer in ohm range

h4 error for ar-5316 error h4 it's tingling H & 4 reapitedly Fuser not heating up, likely cause, lamp or thermal fuse. Hope this is of some help Ed

Sharp ARM-205 reading error code H4 what is this? H4 is usually a fuser fault Faulty fulse lamp or thermal cut out. I would suggest you contact your service centre

...copier, where is the fusing unit thermal breaker? its on the motherboard i believe, I used to repair copiers as a tech in the late 1980's Its directly above the heat roller where you will see an ...

...COPIER Sharp 8100 file of manual http://files.mail.ru/N4G1OG Please vote for me for my answer. Senks) Код ...

How to problem sharp AR-M237 erroe code H4-01 you have problem with the fuser temprature maybe the the heater lam or may be thermal fuse just check bothe if ok just reset. thanks

copier is turned on? A H3 code means that there is a problem with the fuser unit. You can try to clear th code in service mode, but it may come back. You may have a blown thermister or thermal fuse or

what does the thermal fuse look like on copiersi have a konica minolta cspro 3000 which thermal fuse? the one(s) in the fuser? The fuses or the thermistors? There are thermal safety devices everywhere