...cap.(coil is inside) There are no other wires involved except for the short harness that goes directly into the distributor that connects the coil, pickup coil and control module to each
...I've also cleaned all points in the distributor cap and tested the plug wire leading from the coil to the distributor cap. its working fine but still no spark...??? Test the pickup with test
...pickup coil but either one can cause the same identical stalling problem. I keep a few known good modules around as test units so I can just replace a suspected bad module and road test it to see if ...
...Pickup Coil Actually, I just need to know how to remove the Distributor Shaft Gear on my 1988 Ford Bronco II 2.9L V6, so that I can change the distributor Pickup Coil. I removed the gear/Shaft roll ...
...coil, or the module or pickup in the distributor. The pickup coil in the bottom of the distributor acts as a cam and crank sensor. You may need a repair book or shop manual to get the test
...pickup coil" inside the distributor to send a "distributor reference pulse input" to the computer. This serves much the same purpose as a crank position sensor. The little star-looking ring on the ...
Question about 1988 C/K 3500
...tbi have replaced distributor, map, etc, coil, fuel pump and filter Checked timing? Ignition wires all good? Misfire under load may indicate bad wires. have you replaced distributor or just the
...pickup coil in the bottom of the distributor checked. If you have spark, you need to check for fuel pressure. If you have none, check and make sure you are getting power to the fuel pump. If you have ...
Question about 1988 C/K 3500
...pickup coil to distributor and also how to connect ignition control module. ...
...test that this is first. if fails the distrib is bad, VR pick up. s15 jimmy or PU which engine, 2.5L 151cid L4 2.8L 173cid V6 4.3L 262cid V6 <<<< I will guess this and answer. try new ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions
