Question about Neptune MAH5500B Front Load Washer
...test and pushed the extra rinse button to unlock. We hhear clicking sounds, but the door remains locked. How does one get to the emergancy cord to open the door? Any thoughts on what part may be ...
overfill or do did it leak the water out from somewhere? Typically, if the washer is overfilling it is caused by a faulty water level switch. This is a diaphragm like device with a small clear plastic
...the water. Make sure there is no damage to or obstruction in the plastic tube. The switch can be tested using a multimeter or ohmmeter. Check for continuity. A lack of continuity means a bad
...switch {test & replace} stuck inlet valve test clean or replace . level switch is located in the control panel it will have an air tub connected to it. set vom meter on RX1 look for 0 on one ...
Question about 25 in. TempStar HH Free-standing Dishwasher
...test this? The sensor is a plastic pipe (vacume) / and a ajustable switch. The rise in water causes the air pressure in the pipe to increase and at the set level this stops the water inlet valve. You ...
sounds like its burned up from bag being overfilled , now you have to get to the vac motor test it with switch on to see if its getting power if so then motor is burnt.use an ohms meter for power test
Question about Electric WCVH6800J Front Load Washer
...test the pressure switch hose? Here's a similar posting that explains a potential issue and how to troubleshoot: http://www.fixya.com/support/t8933273-general_electirc_washer_model I highly ...
...test either, it did spin though. What's my next move? Is it time for the trash heap? Thanks, Doug FL Flood Condition FL flashes if any overfill condition occurs. This condition occurs when ...
...Overfill is cause mainly by pressure switch, check the pressure switch by measuring the connectivity of the switch when blowing to the hose tube (for old models top load only). For newer models the ...
Question about Calypso GVW9959K Top Load Washer
...when it shouldn't, but also the machine is not telling it to stop when the machine is overfilled. I tested both inlet valves with a multimeter and, electrically, they are working properly. Any ideas ...
Usually answered in minutes!
9,125 Questions
3,839 Questions
3,158 Questions
2,979 Questions
2,660 Questions