...ignition ON. Connect LED test lamp between terminal 7 of the engine diagnostic connector and earth Fig. 84765. Diagnostic connector located adjacent to left or right-hand turret or on bulkhead. After ...
...stuck together by dissconecting the relay the test light should go out if you suspect the ignition switch unplug it and the test light should go out if so change the switch if it goes out ...
test light: Turn the ignition key off and disconnect the wire connector at the module. Disconnect the S terminal of the starter solenoid to prevent the engine from cranking when the ignition is in the
test your pickup coil, ignition coil and cdi box. the ignition switch can be tested with a test light and the kill switch should not be grounded unless activated. (hook a test light up to the positive
Question about 2006 ION
...Ignition OFF, test for less than 1.0 ohm of resistance between the ground circuit terminal D and ground. ?X If greater than the specified range, test the ground circuit for an open/high resistance. ...
Question about 2008 Chevrolet Uplander LS
...test the ignition circuit for a short to ground or an open/high resistance. If the circuit tests normal, refer to Power Mode Mismatch. Ignition OFF, connect the harness connector at the multifunction ...
Question about 2008 Chevrolet Uplander LS
TEST B: THE KEY-IN-IGNITION CHIME DOES NOT OPERATE CORRECTLY Do you know what the GEM - genaric electronic control is ? You need a scan tool to check ignition switch position .Don't know if this would
Question about 2008 Chevrolet Uplander LS
test lamp to battery negative. Probe ignition switch terminal B. Lamp should light, else fuse or wiring from battery to switch fault. Turn and hold switch in START position. Ignition switch S terminal
Question about 2003 F-150
...TEST C: THE KEY-IN-IGNITION CHIME DOES NOT OPERATE CORRECTLY CONDITIONS DETAILS/RESULTS/ACTIONS C1 CHECK THE IGNITION STATES - MONITOR THE GEM/CTM PIDS NOTE: If the vehicle is equipped with a manual ...
Question about 2003 F-150
...test the electrical continuity of the ignition switch. Disconnect the Battery: For safety, disconnect the negative terminal of the battery. Access the Ignition Switch: Remove any panels or covers to ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions