Questions & Answers for: test coil 98 chevrolet k1500

98 chevy 1500 loses power 98 chevy 1500 pu loses power when it warms up, new coils new ignition module new plugs new wires no change, runs great when you first start it, when it warms up, idles ,no ...

fuel gauge k1500 98 Z71 fuel gauge vibraiting or bouncing k1500 98 Z71 fuel gauge needle vibrating or bouncing gauge failing (dash)

...98 Chevy K1500 Pickup. Both handles on the driver's door broke yesterday. Was able to get the door open to replace them but when I shut the door to test the operation of them the door would not open ...

...98 chevy z71 4x4 pickup i have no spark and a cod p1361. new relutor cranks sensor and still no spark whats the problem PO 1361 ignition control circuit low voltage. Check your ignition module and ...

Chevrolet 1500 4x4 with a 350 stopped running. Checked the fuel pump changed the rotar cap rotar button and the coil. What else could it be? Replace the pick up coil in the distributor,they are bad to

k1500 died changed coil dist wire from coil to dist have fuel no spark any ideas thanks remove dist cap and rotor, under the rotor there is a control module (its about 1/4" tall, 1" wide, and 2-2 1/2"

98 K1500 4X4 5.7 - CRANK, NO START, FUEL SAMPLE IS CLEAN, PRESSURE SEEMS O.K. THOUGH I HAVE NOT MEASURED IT. 12V AT THE COIL AND DISTRIBUTOR (BOTH NEW) AND NO CODES. I STARTED THE TRUCK AND RAN IT FOR

...coil for it to fire engine and how to check. Chevy v6 pickup 98 model Did tune up and changed distributor and cap Voltage at the coil will be whatever your battery voltage is. Should be 12.6v with a ...

...,checked crank sensor cam sensor,replaced coil,checcked coil wire ,checked power to coil,checked fuses, while cranking check with a test light that the coil is getting a signal from the ecm to

...coil is good 98 Camaro 3.8th what do I check next 98 Camara 3.8l. So I am not getting any spark out of one of my ignition control modules. Replaced it. No spark. So moved my coils around and the same ...