...Ignition Coil Test by SmallEng.com http://www.youtube.com/watch?v=L7WNBDRG4C4 You may need to use a jumper wire between the threaded part of the plug and the cooling fins. You don?t have to bend up ...
...Chainsaw has no spark. The electrnoic (they say) ignition is 2210 ohms between the lead and ground. Another older MAC has straight coil 879 ohms which suggests it may be the electrnic ignition unit. ...
Question about Oregon Chainsaw Chain For Stihl Chainsaw 24" Bar Length 84 Drive Links 3/8 0.05 Gauge Chiesel Chain
...chainsaw. I replaced the coil and spark plug. still no spark?? check the ground wire on the on and off switch, it could be a bad ground Where did you get the coil? How did you gap the coil? Reply ...
Question about Pro 42CC 2 Cycle Chainsaw, 18"
TEST IGNITION COIL ON A POULAN CHAIN SAW MODEL 2000? ALSO WHAT IS THE AIR GAP ADJUSTMENT FOR THE SAME? Ignition Coil Test by SmallEng.com http://www.youtube.com/watch?v=L7WNBDRG4C4 You may need to use
...Ignition Coil Test by SmallEng.com http://www.youtube.com/watch?v=L7WNBDRG4C4 You may need to use a jumper wire between the threaded part of the plug and the cooling fins. You do not have to bend up ...
Question about 350 18 Inch Gas Chainsaw 52CC Fully Assembled Brand New 18"
...chainsaw. I would like to know the resistance value between spark plug wire and blue wire from ignition coil, and between spark plug wire and the ground and finally resistance between blue wire and ...
Question about 350 18 Inch Gas Chainsaw 52CC Fully Assembled Brand New 18"
...blower The acid test for the ignition unit is to crank the engine with the spark plug out and earthed against the cylinder, if there is no spark ( with the ignition switch on ) then the unit is
Question about "Chain Saw - 16" Bar, 3 Hp
...chainsaw i have tried disconecting the kill switch and fiting a new spark plug but still no spark could it be the coil pack and lead or magnets in the fly wheel , where is the best place for cheap ...
Question about New Chainsaw PS-3410 TH TLC
...test a ignition coil on dolmar ps-3410 no spark Replace the coil I have found this is the problem most of the time but first disconnect the kill switch wire from the coil to make sure the switch is ...
Question about New Chainsaw PS-3410 TH TLC
...know by pressing the helpful button. Check out some of my other posts if you need more tips and info." Chainsaw Ignition Coil Test Poulan Chainsaw Ignition Controls Parts Poulan IGNITION COILS ...
Usually answered in minutes!
1,998 Questions
1,006 Questions
778 Questions
1,057 Questions
700 Questions