Questions & Answers for: IBM 6400 test

...but I have not had any success in finding the drivers. Please help. Try running couple of these test, to see if it might be another issue. It should be printing these test at 1500 Line Per

Testing Hardware Please Wait When I turn on the IBM 6400. The LED says Testing Hardware and the printer continues to beep. are you running twinax or etherent on this unit?

print test how can i make a print test page for IBM 640-I2S Step Press Displayed Result Notes 1. Install the ribbon, load paper, and power on the printer. 2. NOT READY Printer must be in NOT READY ...

IBM 6400 Stuck At Testing Hardware I am using an Ethernet connection. Hello Edward, Have you tried reseating your memory yet? If so try disconnecting your 10/100 card and turn it on. If this doesn?t ...

I replaced the shuttle and need to do the phasing adjustment. Can you tell me how? IMPORTANT The printer must be printing the Phase pattern of ?H?s? when the Phasing Value is changed, or the New ...

...the hammer bank logic cable even if there is no damage to cable seen. You might do the cable shorts test recommended on page 263 of service ...

how to printest page On your computer, click on start-go to settings, now look for printers and faxes, click on it, it will display your installed printer, right click on the name of your installed ...

The screen on the printer is stuck in testing hardware mode and is beeping. We cannot print anything. What can we do? you can first try power off and power on, if that doesn't work you can try ...

...page of text there seems to be no issue with the tractor feed no drag on the paper source and the test prints seen alright thanks in advance Might be your gap is set to high. try moving the right ...

...first entry was accepted. we are currently migrating from RSC 6000 to Redhat and are attempting to test printing reports to an IBM 6400 matrix printer. it prints however it prints the report upside ...