...light comes on when the door is open with power disconnected if any wire disconnected before any test, reconnect & test dryer, reconnect wires after each test disconnect wires from start button
...of micro, look for paperwork on wiring diagram, this tells all the working parts. Look for fuse, test to see if bad. If good, test all cavity switches there must be a bad one, replace and unit ...
...Older top load Magic Chef 20lbs washer will not agitate. All other cycles work fine. Hi, Try these Test the lid switch Inspect the motor coupler Inspect the drive belt (belt drive only) Inspect
cold water inlet will not let any water in Check the filter screens Test the water level switch Test the water temperature switch Test the timer control Test the water inlet valve The water valve is ...
...that the contacts are connected properly, and not loose, or corroded. If all the wiring checks out, test the sensor for the correct resistance readings.(you will need a multimeter for this test) The ...
...knob. One of the thin strips is stuck together. UNPLUG the unit and only plug it in briefly for testing. The top has to be opened by removing all 4 burner caps and removing the 4 screws under the ...
my dryer is not doing anything Your dryer has a thermal fuse about the size of a dime that is located near the element, if it fails the dryer will not start. The fuse can be bypassed for testing ...
Question about CMV1000B Microwave Oven
...is to make sure power is coming off your control board at the MW relay. Make sure of the wires and test here, if you have 120 volts at this point, you have ruled out a lot of parts that could be the ...
Question about CMV1000B Microwave Oven
...the refrigerator and turn off the water supply to the valve before working with this part. (HOW TO TEST INLET VALVE:Inspect the filter screen where the supply line connects. Remove any debris or ...
Usually answered in minutes!
80 Questions
27 Questions
30 Questions
20 Questions
13 Questions