Questions & Answers for: GMC Jimmy tensioner

...is broke, wath can i do to disconnect the compressor? and keep the motor running with another belt tensioner, can i used other belth so the motor can run? my original belth tension is: DAYCO POLY

how do i put on the serpintine belts You will have to locate the belt tensioner ( if this has a serpentine belt setup) just put a wrench on the bolt where the pulley is and turn until you release the ...

squealing noise would it be tension pully Tension pully or a/c clutch Ihad the same problem. Turned out that the belts do wear out without breaking. Try replaceing your belts

...coming off the idler polley Check the alignment of the pulleys. Most common problems are: 1) Belt tensioner. 2) Idler Pulley. 3) Crank Pulley (Vibration Dampner) sounds like somthing is out of line

tension pulley for serpentine belt making noise The Tensioner Pulley Bearings are failing and either the Tensioner Pulley or the Tensioner Assembly (Pulley, Arm and Base) must be removed and replaced.

How do you change the serpentine belt? Manual says to use a 1/2" breaker bar on tensioner but I cant see where to put the bar. I dont see a 1/2" hole. have never worked on this model but i should ...

...Jimmy ? After replacing the belt tensor I see no movable part in order to place the fan belt. the tensioner is spring loaded .. you can use a box wrench or somtimes a ratchet wrench (into a square ...

...jimmy if you have a 4.3 or a 5.7 heer it is......HAVE FUN Its easy look at the front of the belt tensioneryou;ll see a square hole just below the pully Take an 3/8ths extention for a 3/8ths socket ...

...vehicle. For installation instructions.....Remove belt by placing a 1/2" rachet into hole on belt tensioner and release pressure on belt. Remove belt. Depending on the vehicle you may have to

...and lift the cable off, setting it out of the way while you work. 2 Locate the serpentine belt tensioner. There are two possible locations in the Jimmy for these tensioners. One is low on the ...