...had broken in three pieces. Installed a new pin, installed the distributor with the #1 cylinder at TDC, and it fired right
...rotating the engine. ( may need asst) When you feel the compression that means your coming up on TDC ( top dead center) of the compression stoke. Now turning the engine the same direction align
...marks on cam shafts . but the crank marks did not line up with belt. The crank has got to be at TDC, with the marks lined up, the cams have to be lined up to their marks, then the belt will line ...
pics of camshaft sensor and knock sensor Pics of camshaft sensor and knock sensor http://groups.yahoo.com/group/villagerquest/ cam sensor is in distributor. has optical sensor below lotted wheel. ...
what is correct timing for 98 villager 15 degrees before top dead center, tdc. go here too http://groups.yahoo.com/group/villagerquest/
i replaced timeing belt and now the vehical will not start i checked spark and fuel still nothing cheked tdc and distibuter seems ok. go here' http://groups.yahoo.com/group/villagerquest/ read files.
what is code 325 engine light went on and I put my ob2 on and it read PO325 and PO139, my car turns off whenever I come to a stop sign of light. what could this mena P0325 - Knock Sensor Circuit ...
...the timing for the distributor. If this is the case, Remove the distributor and set the engine to TDC (top dead center). This can be done by spinning the crankshaft pulley/harmonic balancer ...
...TDC, but you have to disconnect the I.A.C sensor to do it.if it's still that far out, you're probably of by a tooth.bring #1 piston to TDC, pull out distributor, turn rotor to #1 on dist cap and put ...
Where is the TDC notch on the crankshaft pulley? I'm trying to time my engine after a rebuild and the TDC paint has worn off of the pulley. On pictures of the a new pulley, the TDC is the far left, ...
Usually answered in minutes!
478 Questions
379 Questions
326 Questions
276 Questions
247 Questions