Questions & Answers for: Hyundai Sonata tdc sensor

...out a noise coming from the timming belt area . I pulled the timming belt cover off and set it to tdc to make sure it did not skip time . And noticed the oil pump timing mark is off about 6 teeth ...

...,remove rocker cover first ,then no1 spark plug.use a long thin screwdriver to watch piston move to TDC then back off a bit and turn cams ,look for slots or a grove on back or front of the cam or two ...

Hyundai Lantra 19999 Timing Mark Does the Crankshaft timing mark sit at 10 degrees BTDC or on TDC when setting the timing are you setting the timing belt or just setting the timing with a light ? if ...

...Sensor connectors, etc.). When you get to this point on the V6, you also have to remove the front engine mounting bracket from the front of the engine (4 14mm bolts, also a 12mm bolt which bolts the ...

My 2004 Hyundai Sonata quit on the freeway 65mph timing belt had had timing belt replaced still will not run smooth. compression test was done and #3 was o compression why or what happened? You have ...

...tdc sensor fault, checked for spark at coils no spark, question is where is tdc sensor located and how difficult is it to replace. Firstly, what's a TDC sensor?.. the crank position sensor? If so, on ...

need to find timing marks for camshaft on 2002 hyundai sonota dohc hi from uk the camshaft marks at TDC should be both cams at 12o/clock positions in line with pointer on on rear of cams on engine? ...

need timing belt marks for 2003 sonata timing belt marks are as follows= crank at TDC marks are at 10 oclock the both cams marks at TDC are at 12 .oclock position marks are clear if you look theoil ...

which is number one cylinder for 2003 hyundai sonata need to find tdc 2.7 6 cylinder For 2003 Hyundai Sonata 2.7 liter DOHC V-6 check this schematic... Hope help (remember rated this) Good luck. go to

after replacing timimg belt engine spiins free like there is no compression check #1 at tdc with distributor/timing marks on both pulleys.