Questions & Answers for: tank latch

tank latch is not down. Push latch down, securely into place. Black Valve on the Dirty/Collection Tank is missing. Replace Black Valve into Dirty/ Collection tank. Usually there is a seal out of place

...tank lid will not snap in place. The back latch will not hold. Can you tell me if I need to order a new lid or the whole tank. If so, can you give me the part number. The latch will latch when you ...

...tank? is the latch faced away from the tank? if so, then grab a paper clip and fold it so you can hook it around the latch then just pull outward towards the tank. you might need to hold that paper ...

...tank? is the latch faced away from the tank? if so, then grab a paper clip and fold it so you can hook it around the latch then just pull outward towards the tank. you might need to hold that paper ...

...tank latch lid and take out the tank lid. Empty the tank. Also check the tank lid screen for debris and remove any found. To replace the lid, align the tab that corresponds to the front hole of the ...

...tank cover, and apply pressure with thumb to each latch until it snaps tightly in place. Make sure all lid latches are clamped securely. Are you sure that the filter is pushed all the way to the ...

...latch that controls the gas tank door and the trunk is not working. I can not open gas door and can not close trunk emergency release should be in the trunk as for the closing of the trunk, you need ...

...I can not find the latch that opens the fuel tank just bought the car the trunk latch is in the floor on driver side but I can not find the gas tank latch The latch works 2 ways push down or pull

...latch to the tank. I made sure the seal was clean of dirt/debris, and it won't quite latch. I've used the cleaner about 5 times. Hire a professional to steam clean your carpets... and never use a ...

...latch slots on the sides of the recovery tank. These are the slots where the latches will be installed. Hold one of the latches with the clip facing up and the open end facing the latch slot. Insert ...