Questions & Answers for: Janome tangled thread

Lower right thread (green) keeps coming out of its eye! Following the 'map' I seem to be threading the overlocker correctly, but just today the lower right (green) thread keeps coming out of its final

thread tangled up on backside of fabric and machine stopped. I untangled the mess and started to sew again and same thing happened.. then the machine "died". After reading here how to find and replace

When sewing the bobin thread tangles and jams When sewing the bobin thread tangles an jams on the third stitch, then error message about bent needle or a jam. There is nothing wrong with the needle ...

...thread tangled up? Are you using heavy thread for the top stitching? If so you will need to tighten the top tension. You would think if it is thicker thread that you would need to loosen the top ...

...thread is tangled, or incompatible with your bobbin thread. How is your needle? Is the thread that is tangling from the bobbin? If, so you have your bobbin inserted upside down and the thread is not ...

...ideas why? or how to adjust the tension? It may be how you threaded it , Totally rethread and check your manual , make sure you are doing it correctly, Also, make sure that your thread is not

tangled mess of thread on the underside of the fabric with machine making a bad noise until it stops to tell you there's a problem. Have changed needle and bobbin. Have also cleaned out the hook race ...

...thread of my bobbin becomes tangled and the needle stops. I end up with a large tangle of thread Make sure you are putting the bobbin in right side up. Some times it will do this if your needle size ...

Thread gets tangled underneath Start sewing and thread gets tangled around the bobbin post around the post? is the bobbin and bobbin case in the machine?

tangled mess in bobbin area and thread breaks, I have changed bobbin,needle threaded rethreaded changed tension and still tangled mess. it takes a few turns of wheel to get it to pull up bobbin thread