Questions & Answers for: Ford Bronco tailgate problems

...a fuse but my other power windows still work. Any ideas? if there are no broken wires inside the tailgate try lubing the latches with WD40 and open and close the tailgate several times. If the ...

key and dash switch for rear window does not work I took the panel off the tailgate and put power to the motor and the motor works up and down Try pushing on the top of the tailgate above the keyhole ...

...as well as the switch on the dash. The dianosis for the problem they said the switch that works the tailgate is bad and you can buys those anymore. They said that something in the tailgate stays on ...

tailgate regulator...can't get to it because window is down rear window (tailgate)....regulator needs to be replaced but the window can not be put up so i can get to the regulator any ideas?..please ...

...relay switch and etc? Thank you. the most common thing people over look is the safety switch in the tailgate it is either on the bottom of the handle or the drivers side latch you can replace it or ...

...and down operation. I had planned to replace the dash switch to restore "up" function, but now the tailgate key switch will not power the window down. The window is currently in the up position, so ...

My rear window won't operate. Can I manually lower the window? The dash switch nor the outside tailgate switch will operate the window. No blown fuse. What could be the problem? Have had a few of ...

Have a 1992 Ford Bronco Eddie Bauer Tailgate window motor problem Have a 1992 Ford Bronco Eddie Bauer edition. The Tailgate power window will only run in one direction when connected to the vehicle ...

i just bought a 1996 ford bronco to day and the rear window worked then i tried to open tailgate and now it wont work ? can you help. This is a pretty common problem, Inspect the wiring in the ...

1991 bronco tailgate window regulator.. I can not just buy the motor. it comes with regulator... it says to remove motor from regulator... I did, now I am having hard time getting the motor back into ...