Questions & Answers for: Suzuki Boulevard C50 tail light assembly

...out a rear taillight on c50 2006 model THERE IS THREE BOLTS UNDER THE REAR MUDGUARD (FENDER) THEY ARE DIFFICULT to get at. once they are removed the tail light unit will pull forward. hope this

...tail light assembly on 2008 suzuki C50 How do you remove tail light assembly on suzuki c50. I have removed the 4 bolts but can't find a connector in the wireing unscrew the buld socket from the light ...

...tail light assembly. How do I get to the bolt to take the turn signal off and replace it. You willl have to loosen the nuts that retain the tail light assembly to the fender, then access the turn ...

rubber boot that hold tail lite to rear lite broke and where would i find a replacement or do i need the whole thing? you can order that from Suzuki

...soft plate in front removes with a single screw from the bottom center. it makes access to the nut holding on to the light assembly. the headlight must be removed to get to the end wire

...and charged, can you advise please I am also having the same issue with my 07 C-50 I rode to work today no problems. Got on to go to lunch no power to anything except the tail light and 4 ways Tony

how to replace timming chain on c50t tried to start it sounded like some thing broke in motor Timing chain set fast piston wheel set without nut assembling.then moving piston wheel softly nut position

...had a dealer find the problem on there bike. i m still lookin i thought key switch but i have one tail light workin all flashers work and sometimes the fuel pump wont start its a very crazy

...tail light is not workin dont know if the problem is connected.the tail light is not gettin power but will work when flasher is used sound like the harness may have a bad connector in the loom your ...

...light resistance is felt. Then back the screw out 1/8-1/4 turn and holding in that position lock the nut. Use the cable adjuster at the lever under the rubber boot to acieve a slight amount of free ...