Questions & Answers for: Nissan Altima tail light assembly

...tail light access is in the trunk. Usually a panel will have to be removed ( kinda like where a jack would be ) then there will either be 1: nuts securing the entire tail light assembly which you can ...

...tail light assembly through your boot just open boot and eitherside you should have removable sockets for your lights under your carpets just unscrew the plastic carpet holders behind that is your ...

...light assembly are out. Where is the fuse that controls these? Check the earth (chassis) connection. If all the lights are out it won't be a fuse(indicaters and break lights and tail lights do not ...

...tail light assembly. Squeeze the back side of the clip and pull on the front of the clip until it snaps out. There are then two 5/16 nuts which must be removed. These are hidden by plastic wiring ...

tail light assembly in place. Remove them. The fender side of the taillight is snapped on. With a little hand force (don't use a screwdriver, it may crack the light or scratch the paint) you should be

...connectors on 8mm bolts. Remove them using 8mm ratchet socket adapters. Then you can lift and pry off the tail light assembly to get to the bulbs. Then do the reverse to put it all back

...light bulb. This is what the tech data says: Tail LightsDisplace trunk room trim as needed. From trunk, remove nuts securing rear combination lamp assembly. Disconnect connectors and remove assembly. ...

...how to change rear break light.s could not figer out to remove the hole assy You should be able to gain access through the trunk, inspect the trunk wall near the tail lamp assemblies for service ...

removing tail light assemble 2005 altima Pop the trunk and remove the carpeting/covering in the rear off of the sides, and you will be able to unscrew the tail light.

remove tail light assembly 05 altima having water get in the trunk the seal is bad around the tail light assembly, need to take whole assembly off to inspect Here's a link on how to remove.