tail light fuse then check it. If not then pull them one at a time and replace any you find that are bad. If none turn out bad then there is a relay in some models after the fuse. It should be mounted
...or cruise My denali has lost it's brake lights and cruise. All other lights are working correctly. tail lights and turning signals all work. What I think it is, is the brake switch on the brake
Question about 2002 Yukon XL
...Tail lights OK Where do I go from here? Thanks Ed Travis 435-731-7713 Check your brake light switch at the pedal. This controls the lights and disengages the cruise when stopping. I'd look there ...
...tail light assembly off in order to change the brake light in my 08 yukon xl? the nuts to remove the light assy. are located in the cargo compartment you may have to remove a plastic panel to gain ...
...tail lights stay on and I can not turn them off. I found my battery dead yesterday morning and I replaced the battery thinking it was the battery and the lights were just a warning light, but it's ...
...truck parking lights dont work, or the trailer running lights dont work? Does the trailer just have tail lights or does it have front and rear side markers? I think you mean the trailer lights. Check ...
...tail light assembly. Take out those two screws (keep one hand on the assembly when you remove the last screw) and the whole tail light assembly will come off of the vehicle. On the back side of the ...
Question about 2000 Yukon XL
...Tail lights and dash light fuse keeps blowing ? http://technoanswers.blogspot.in/2012/02/tail-lights-and-dash-light-fuse-keeps.html---------Heater makes clicking noise under dash on Ford Explorer? ...
...failed for inspection...but so can water or condensation in light.. Replace assembly a seal is bad or cracked The bottom light is held in w a tab behind light once top section is out it will visible ...
Question about 2007 Yukon XL Denali
2007 Yukon Xl Denali can the headlight switch/dimmer cause only the tail lights to not work. Dash lights, signals, brake lights when pressed work. Both sides went out. No blown fuse or broken wires. ...
Usually answered in minutes!
721 Questions
500 Questions
426 Questions
169 Questions
128 Questions