Questions & Answers for: Ford Explorer tail light assembly

does not work. Changed light bulb and still did not work. Ohmed out the bulbs and even the original seemed to be ok. Are you getting power at the tail lamp assembly? Better yet, do you still need help

...tail lights stay on when brake is released. This may not help but it is a possible source of the problem. With a flashlight, crawl half under the dashboard and follow the brake pedal suspension up to ...

...tail light. I believe ther is 2 phillips head screws right where the light meets the rear hatch on the body panel. remove them and gently yet firmly pull the lens assembly from the corner of the rear ...

Brake light replacement can't find screws to reach brake light to replace open the tail gate they ( the tail light screws) are right there, u have to remove the entire light assembly, it is easy

...tail light assembly I need to replace the driver side rear tail light assembly on a 2004 Ford Explorer. I have the replacement part, just don't see how to get it out without removing some of the ...

...tail light assembly from the front towards the rear some times it takes a good jab with the heel of your hand to pop it loose, it is held by plastic clips/ Then remove sockets and replace bulb. ...

it. the front washer works fine I think the tank is in the back. When you open the lift gate, there should be a black rubber cap on top of one of the tail light assemblies. I believe the driver's side

...tail light Lift the tailgate and you will find two screws at the top of the lens assembly, remove them. Pull on both sides of the lens directly out from the vehicle as there are two ridged prongs ...

...tail light assembly you will find two screws. Remove the two screws. Now grasp the plastic tail light assembly firmly, and pull it strongly backwards. It is held in place with three spring-loaded ...

tail light sockets are clean and hold the bulbs tight,,make sure all the connections are tight...especially going into the light bulb sockets.. .. reply on here to me.... if this helps, please mark as