Questions & Answers for: t1 reading

T1 camera. Most of the pictures I take comes out blurry and ghost like. Reading some of the reviews, it seems this is normal for this camera. How can I tweek this camera to take better pictures at low

...around the fact you are stuck on "T2" time mode. This is found by a symbol that reads either "T1" or "T2" directly above the seconds. So first make sure you are in "T1" by holding the ST/SP ...

...T1 feb 04 and the other day I turned it on and the screen was all grainy and different colours! upon reading other blogs I see this could be a sony free fix fault is this right?? How do I go about ...

sony DSC T1 Hello, I'm not technical at all, but I have read your comments and gone into Sonys uk support page 2 as suggested by you to someone else. The LCD on my camera is also black. I can't see ...

...read at least 0.5 ohms. You should have T1 and T2 reading 0.5 and T3 and T4 reading 0.5. T1 and T3 should read opened, T1 to T4 should read opened. Also, T2 to T3 should be opened and T2 to T4

...Reading the document at the below link describes a black screen, a test you can use to see if that's the problem, and if so, you can mail the camera to Sony for a free repair. Here is Welcomejee's ...

...sensor. Error can only be reset once the display reads E.nOH. Causes: *Resistor at terminal T1:T2 > 1650 ohms * Motor overloaded (getting hot) *Temperature sensor defective compaq nx6310 ...

...Ignition off door closed, Hold T1/T2 and eenter button turn on ignition hold for approx 6 seconds until dash complete check then will show speedo reading release buttons...Job done.By Jeremy de

how do I reset my sony cyber shot dsc-t1 to it factory setting cant see anything I want to take a picture of when I turn the camera on nothing comes on the screen to see what Im trying to take a ...

how can i bypass or jump the fuel pump on my 1990 camry I read it on here but now i cant find it again. I thought i read jump b to T1 on the diagnostic box under hood fp to b+