...unlock vehicle. Switch ignition OFF. Remove key. Check operation of all programmed remote controls. NOTE: If less than 3 remote controls are to be programmed, remove ignition key after programming ...
...switch lock or unlock actuation ?€¢ A keyless entry transmitter actuation ?€¢ An automatic door lock or unlock actuation ?€¢ A last door closed locking (LDCL) actuation If the driver door cylinder ...
Question about 2006 Monte Carlo
...switch unlock actuation • A keyless entry transmitter actuation • An automatic door lock actuation (Personalization function) • An automatic door unlock actuation (Personalization function) Door Lock ...
...unlock switch is detected. The passenger doors lock directly by pressing the lock switches. The driver door unlocks by the BCM using a driver door unlock relay. • All the doors lock -- All the doors ...
...switch lock or unlock actuation • A keyless entry transmitter actuation • An automatic door lock or unlock actuation • A last door closed locking (LDCL) actuation If the driver door cylinder switch ...
...switch lock or unlock actuation • A keyless entry transmitter actuation • An automatic door lock or unlock actuation • A last door closed locking (LDCL) actuation If the driver door cylinder switch ...
Question about 2006 Monte Carlo
...switch lock or unlock actuation • A keyless entry transmitter actuation • An automatic door lock or unlock actuation • A last door closed locking (LDCL) actuation If the driver door cylinder switch ...
Question about 2006 Monte Carlo
...unlock switch activations. • Front passenger door lock switch--Provides a switched voltage signal to the BCM for both lock and unlock switch activations. • Door lock relay--Located in the instrument ...
Question about 2006 Altima
...unlock switch terminal 5 (16). With ignition switch in ON or START position, power is supplied ? through BCM terminal 68 ? to main power window and door lock/unlock switch terminal 12 (17) ? to front ...
Question about 2006 Altima
...unlock switch to the LOCK position for more than 5 seconds. 4. The switching is completed when the hazard lamps blink. 5. The ignition switch must be turned OFF and ON again between each setting ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions