...be faulty the delay switch and should be cheaper than replacing your washer there is nothing you can do if this part is faulty sorry for the bad news m8 it is only a small circuit switch to ...
faulty lid switch (door switch). Try replacing this as well. If the door is not recognised as being closed, the machine wont start. Lastly, I would re-check the control board for faulty wiring. If you
...drain can be caused by the following conditions: Faulty pump faulty timer or switching ( most likely in your case ) faulty door switch ( second most likely ) Blocked pump Blocked outlet Hope this ...
Question about Duet GHW9150P Front Load Washer
...FAULTY F08 indicates pressure switch stuck on full. Unplug the appliance from the wall socket. Take the top off the machine. Locate the pressure switch, you can identify it by the thin tube attached ...
...pried open and door switch will have to be tested or replaced. You can use a multi-meter or ohmmeter. Worst possible cause is faulty eprom or control board but usually is faulty switch or door
...Anyway, I hope I am wrong and best wishes. (Don't forget to test the door lock switch. Use a multimeter and check for continuity. A lack of continuity indicates a faulty switch. Hope this
Question about Duet GHW9150P Front Load Washer
...the plastic tube. The switch can be tested for continuity using a multimeter or ohmmeter. A lack of continuity means a faulty switch. Really sorry for your trouble and I hope this helped. Best
Question about Duet GHW9150P Front Load Washer
...faulty or worn. The door lock/switch assembly is part number 1094190 and costs about $55. The switch striker/actuator is part number 906446 and costs about $5. Door Lock/Switch Replacement Procedure ...
...assembly, which is what this fault code is telling you. Most often caused by a faulty switch within the lock assembly itself, you will need to replace the entire assembly. The part is available HERE
...clear. Next blow into the little fitting on the switch , if the tube is ok ,and it should click. Either the switch is faulty or the tube is blocked,detached from the machine or burst. Hope this
Usually answered in minutes!
9,125 Questions
187 Questions
64 Questions
34 Questions
