...switch is faulty, the machine will not operate. Here's how to test and repair a door switch:Step 1: Latch the door and hold the latch tightly in the closed position. This works best on a unit with a ...
Question about AWM6120 Front Load Washer
faulty water level switch, or membrane sensor, depending on the model. A faulty or clogged inlet valve can also close few seconds from opening the valve, usually becausu of a faulty solenoid. If valve
faulty water level switch, or membrane sensor, depending on the model. A faulty or clogged inlet valve can also close few seconds from opening the valve, usually becausu of a faulty solenoid. If valve
...drain can be caused by the following conditions: Faulty pump faulty timer or switching ( most likely in your case ) faulty door switch ( second most likely ) Blocked pump Blocked outlet Hope this ...
Question about Ultimate Care II LSQ9549L Top Load Washer
...faulty lid switch stop basket from spinning Lid switch is safety mechanism that cuts off power to motor when lid is open. If it is broken or faulty you will not get power to motor during spin. Hope ...
Question about Gold 24 in. Built-In Dishwasher Dishwasher
...machine to think that there is still water inside, even when water has drained completely. Check if sensor is stuck or if switch is faulty.Some machine may use a membrane switch instead of a
Question about Gold 24 in. Built-In Dishwasher Dishwasher
filling with water water valve is faulty or the fill level switch is faulty. the only other thing it could be is if the tube going from the fill switch to the tub has either come off or gotten clogged
Question about Gold 24 in. Built-In Dishwasher Dishwasher
...faulty light switch or the short in wirings from bulb connector to light switch.In most of the cases its faulty light switch.It has to be checked and replaced.----------This should ...
humming noise from control panel when pluged in control panel hums This usually means that a micro switch is faulty, check the micro switch and replace if faulty, there should be two micro switches
...It is usually one the following issues: Door switch is faulty or door doesn't close properly, belt tension switch, Thermal fuse is burnt (due to clogged vent or faulty blower), main control is
Usually answered in minutes!
915 Questions
493 Questions
219 Questions
129 Questions
99 Questions