Questions & Answers for: ViewSonic on switch faulty

...switch it on after a week it comes but does not stay for long. I have been informed by my engineer that may be the EHP is faulty, can you please let me know if this could be repaired or I hve to ...

switch...the red light stays on; however it is not blinking...worked fine yesterday...when I got up this morning, it just simply woudn't turn on. Hello mike this problem could either be that your main

WAN indicator light is OFF is this router dead? Greg, Not yet. We dont give up so soon. May be that the poweron switch is faulty. Replace it and see if it works.

...up and screen going on and off till is warm. If i keep it on all the time there is no problems. But switching it on in the morning takes about 20 min to get normal. When I bought this monitor lasted ...

...inside to fail slowly, this may be resistors and capacitors, or a slow blow fuse, and a faulty switching regulator IC, then stops. Servicing LCDs are quite difficult, you need to bring it to

...SWITCH MY MONITOR ON IT IT CUTS OUT BUT LIGHT IS STILL GREEN I would check the power cable is inserted fully, then check PC to monitor cable is also inserted firmly. If still same try monitor on ...

...so, is this with the remote control ? In such a case it is possible that the standby switch cirrcuit is faulty, the otptocoupler switching device may be faulty, the mP switching circuit may be

...switch the power off and back on, all is OK for about half a minute theh fails again. Please advise One bad lead can cause a computer to continue on a cycle or to shutdown or fail to detect/ boot up ...

...Switch on the projector 2.select menu and the select lamp setting 3. In the lamp setting menu select lamp Reset and execute the same After doing this if the problem remains then you have to check two ...

My monitor switched to a blue tinted display with low resolution and I am unable to change it in the properties menu? Look to see if cables are ok in the back. You may have a faulty cable or faulty ...