Questions & Answers for: suzuki motorcycles piston rings

...piston numbers 0,5 and 1mm oversice hello i,m jeroen from holland. i have a rg 400 whit broken pistons. the rg400 is never sold in holland my suzuki dealer can,t find the numbers for pistons gasket ...

...piston. Since you're asking this question here, I assume that this is not the case. I'm not familiar with Suzuki DR-Z 250. In the case it's four stroke with three rings, two compression rings and an ...

piston, this points to the exhaust port,2 strokes have locating pins for the rings and the end of the rings go to these pins,as you will not be able to get back into the barrel if not fitted like this

...rings. Look at number 14 and 15 in the list. http://www.bikebandit.com/2005-suzuki-motorcycle-dr-z125/o/m5889#sch505648 If you found this answer helpful please leave a good rating for me. Thanks hope ...

...Suzuki rm 125 kick starts with brand new spark plug then eventually bogs down and dies, does the same when push started, does it need new piston and rings? HI,,sounds like your plug is fouling,,what ...

piston an rings on rods already plenty of oil on the rings (even if experts tell you to fit dry) You just need to tilt the barrel a little to get the first piston started in the bore for pistons 2 and

...piston rings motorcycle I got it given the bike by my neighbour, has no piston rings. runs but blows a heap of white smoke. is this something that can be fixed easily or should i not worry. Piston ...

I cannot find Piston rings, cylinder heads or cylinder walls to restore my Suzuki Intruder VL 125 (K6) to full compression. Any ideas where these parts can be ordered from? try wiseco pistons, rings.

...suzuki gsxr 1100 im doing this again whey was there only 85% of presure on the fourth silinder only 1st 2nd 3th were fine 150 thene the fourth silinder was making a sound tingling or ringing sound. ...

...piston ring of suzuki tsr 125? please i need answer Very carefully! To get the piston rings on, a good trick is to carefully slide them over a couple of very thin feeler gauges. This way you don't ...