...sounds like you have either a switch mode power supply problem that is not developing your Vs or Va sustain voltages to your Y sustain panel, or the Y sustain panel is defective. The only way to say ...
...color There is a couple of problems that will cause this symptom. The lower y-buffer board, y-sustain board, or the z/x-sustain board, on rare occasions the power supply. Most manufacturers
...to open the television to troubleshoot and replace faulty component. The problem is the from the Y sustain board,However normally they have to change both Y sustain and Z sustain boards at the same ...
...LI4101199A what would something like this run? My unit is 7 years old. if you are replacing the X-Sustain / Z-Sustain Board yourself, the part is 179.95 + 10-15 s/h ...
Question about SP-R4232 42 in. Plasma HDTV
...of good and bad I'm geting purple picture a mixtures of good and bad Hi it sounds like your sustain boards are going bad. The sustain boards are located on the left and right side ...
Question about SP-R4232 42 in. Plasma HDTV
...the power supply board but still the symptoms persist, then the suspect is either the X or Y sustain board but high chance that the fault came from the Y sustain board based on my experienced. ...
Question about SP-R4232 42 in. Plasma HDTV
...plasma has pink dots across picture when watching tv, what could be wrong Hello, the x or y-sustain boards are going bad, most likely the y- sustain. It will slowly get worse until it is ...
Question about HPT5054 50-Inch Plasma HDTV
...Model HPT5054X/XAA 50" plasma TV. the picture went black but still have audio.I purchased a reman Y sustain board.The Y buffer boards looked good. Now when I reassembled the unit,st Replaced the main ...
Question about HPT5054 50-Inch Plasma HDTV
samsung 50 in plasma clicks off when you turn it on but if you unplug y sustain board it will power up with no pic have replaced power board If it shuts down when you plug in the Y sustain board, what
Question about HPT5054 50-Inch Plasma HDTV
...which does not have a picture when switched on but there is a clicking sound. Replaced Y-Sustain still clicking. Disconnected and reconnected X-Sustain but still clicking. Clicking only ...
Usually answered in minutes!
1,031 Questions
445 Questions
373 Questions
357 Questions
327 Questions