Questions & Answers for: sump screen

debris found in the sump, check the disposal blades as well. You will need a torx style screwdriver to remove the sump screen on this unit. You can buy a set for under $10 at your local hardware store

sump screen, no luck. Does the sump screen on this stove fit into the sump with the open aspect of the screen facing the back of the stove (toward the incoming fule line)? The open end goes toward the

Green light on clean cycle is blinking seven times - cannot reprogram it this usually means the chopper blade is broken or the sump screen is plugged. you will need to disassemble the sump to check

sump to up the back and over the top, it just pulls out but be gentle. Next remove all the screws on top of the screen and pull that out. You will see a gasket seal that is either stretched or broken.

screen and washer won't spin just stops.model is wd860 f-05 usually relates to either the pump being blocked or the sump of this particular model being full of coins, color catchers etc. first keep it

...screen to prevent debris from accumulating. But, over time, some debris may still get past the screens and collect in the sump. This usually results in poor cleaning results due to restricted water ...

low sump air the screen says low sump air pressure after it shuts down I think you have this posted in the wrong section, this is for car and truck problems. Please re-post in correct category.

...your unit is less than 10 hp the low sump pressure is most likely caused by a dirty suction screen or worn out oil pump if its over 10 hp then low sump most likely is caused by a dirty inlet air ...

...time,pressure drops the faster I go, You will need to drop the pan and clean out the sump tube. It isn't a dirty filter that is the problem, it is a plugged up screen at the bottom of the sump

screen that sits on top of the sump plug bolt so make sure this comes out with the sump plug and is free from any dirt/debris. so drain oil clean the gauze screen then refit and refill your oil. check