Questions & Answers for: sub 500

How should I wire my 3 subs to the 500/1 amp??????? How should I wire 3 "12 's to my amp. The subs are all wired together. So there is one speaker wire that supplies power to all 3 subs. Should I have

...500-5 the 4 high channels work but the sub output doesnt and the low ohm light lights up when a sub is connected.....any ideas how to fix or replace what went bad Assuming that you've confirmed that ...

500/1 amp,is it possible to wire them to the amp and how?PLEASE HELP You can connect them in a series/parallel configuration. Put two of them in series and then connect the last one in parallel across

...sub i bought a 500/1 jl audio amp and hooked it up to a 10inw7 sub but it seems when i turn the volume up it cuts off. i cant even turn it half way up because it will cut off and i have the bass on 0 ...

...500/1 to run a jl audio 13w6v2 d-4 ! amp settings for subwoofer wired series ! an amp setting for sub wired parallel ! series would be 8 ohm an parallel would be 2 ohm ! an can this sub be run at 4 ...

...i have 2 solobaric L5s and jl audio 500/1 amp at a high volume a weird distortion comes out of the subs its almost not noticable but at the same time the low ohms light flash with the noise light ...

...500 watts RMS into a load from 1.5 to 4 ohms. Whether your subs have 2 ohm or 4 ohm voice coils, they should be wired in series and the subs paralleled to the amp. The final load to the amp will be ...

ok i have a jl500/1v2 amp with 2 w6v2 subs and i haveing a problem dont no if the amp is two much for the subs becouse i turn the amp to get more tump and the subs pop and the yellow light filkes so i

sub 500 need code I have a dynaudio sub 500 and lost my remote, can anyone help with the secret code? i have several universal remotes but no code. that could be a hard one you have to find the search

how do i wire a 2 speakers to a jl 500/1 I agree with the last answer. I have 1 ten inch sub on my 500/1. it hits great but it would not drive 2 of my Skar wwv dvc subs