Questions & Answers for: Maytag stuck valves

...FAV9800AW has water still flowing with the washer 120VAC power cord pulled then the inlet valve is stuck open. Because you are posting in the Neptune FAV6800AW Top Load Washer forum here is some ...

...flow into the machine with the 120VAC power plug pulled from the machine? If it does you have a stuck water valve. If it doesn?t you could have a stuck pressure switch and I can walk you thru how ...

...valves leading to the dryer are 'on', and the gas water heater I have is working A-OK. Any suggestions? Igniter glows - No gas ignition. If the igniter heats up but the main burner flame is not ...

overflows when filling even if unplugged Hi. Shut off the water valves if you haven't already, the fill valve is stuck open. Will have to replace the fill valve. Hope your floor is ok.

...stay its goes straight out hose so the tub never fills??/ The outlet solenoid valve is either stuck open or there is an erroneous signal from the control unit being sent to the valve.

...the ignitor and the gas valve having continuity the problem has be the gas safety valve bimetal is stuck. The only thing you check is amprage draw on ignitor it should be between 3.2-3.6 (as label

...the washer fills with water while off. I also disconnected the power to see if an inlet valve was stuck open but the water continued to run. Hi from retired Englishman in SW France, 'I also ...

...The one side of valve is working, but other side of the valve is not working. The valve is got stuck in one position Click this link below to troubleshoot the problem: ---- ...

water fills constantly water fills even if washer is off Inlet water valve stuck open, usually because the filter is damaged or non-existent, dismantle valve clean out foreign matter or replace valve.

Wont drain most have a valve that is operated by a solenoid valve, possible that wires have come off, or valve is stuck shut